Hallways, each floor and recommended areas
Key facts
This detector combines smoke detection and temperature-rise detection. When a hazard is identified, it sounds an alert and sends the signal to the system.
Fast alert in case of fire
Monitored alarm system
Key features
- Smoke detection
- Heat detection
- Local siren
- Transmission to the panel
- Detector supervision
- Always-on operation
How it works, technology and installation
DSC PowerG · smoke and heat
Here is what the device detects, how it communicates and what to check before installation.
Detection
Analyzes smoke particles and heat.
Warning
Sounds the local siren.
Transmission
Sends the alarm to the panel and the monitoring centre.
Technical specifications
- Smoke
- Photoelectric depending on model
- Heat
- Fixed threshold or rate of rise
- Radio
- PowerG
- Alert
- Local siren
- Status
- Always on
Recommended installation
- Hallways, each floor and recommended areas
- Away from steam, kitchens and air vents
- Quantity based on the building
Possible alerts
- Smoke or heat
- Low battery or end of life
- Dirty sensor or radio loss
Maintenance and limitations
Test regularly and replace when due. Installation follows the manufacturer’s documentation and local codes.
Professional validation: the exact model, its range, power supply and compatibility with your panel are confirmed before installation.
FREQUENTLY ASKED QUESTIONS
Questions about the smoke and heat detector
Is it compatible with my alarm system?
Compatibility depends on the exact panel model, its radio frequency and the active Alarm.com service. Solution Alarme Plus checks these before confirming the equipment.
Where should this device be installed?
Hallways, each floor and recommended areas. The final location also takes into account radio range, power supply, the environment and the manufacturer’s recommendations.
Will I get alerts on my phone?
Smoke or heat. Available notifications and how they can be customized depend on the configuration and the selected package.